Washington: Reports indicate that scientists are working towards developing paper-based batteries made from algae to power electronics in the future.
According to a report in Live Science, scientists worldwide are striving to develop thin, flexible, lightweight, inexpensive, environmentally friendly batteries made entirely from nonmetal parts.
Among the most promising materials for these batteries are conducting polymers.
However, until now these have impractical for use in batteries - for instance, their ability to hold a charge often degrades over use.
The key to this new battery turned out to be an often bothersome green algae known as Cladophora.
Rotting heaps of this hairlike freshwater plant throughout the world can lead to unsightly, foul-smelling beaches.
This algae makes an unusual kind of cellulose typified by a very large surface area, 100 times that of the cellulose found in paper.
This allowed researchers to dramatically increase the amount of conducting polymer available for use in the new device, enabling it to better recharge, hold and discharge electricity.
"We have long hoped to find some sort of constructive use for the material from algae blooms and have now been shown this to be possible," said researcher Maria Stromme, a nanotechnologist at Uppsala University in Sweden.
"This creates new possibilities for large-scale production of environmentally friendly, cost-effective, lightweight energy storage systems," she added.
The new batteries consisted of extremely thin layers of conducting polymer just 40 to 50 nanometers or billionths of a meter wide coating algae cellulose fibers only 20 to 30 nanometers wide that were collected into paper sheets.
They could hold 50 to 200 percent more charge than similar conducting polymer batteries, and once better optimized, they might even be competitive with commercial lithium batteries, the researchers noted.
They also recharged much faster than conventional rechargeable batteries.
While a regular battery takes at least an hour to recharge, the new batteries could recharge in anywhere from eight minutes to just 11 seconds.
The new battery also showed a dramatic boost in the ability to hold a charge over use.
While a comparable polymer battery showed a 50 percent drop in the amount of charge it could hold after 60 cycles of discharging and recharging, the new battery showed just a 6 percent loss through 100 charging cycles.
The researchers suggested that their batteries appear well-suited for applications involving flexible electronics, such as clothing and packaging.
First Published: Sunday, November 29, 2009, 13:38