New device can detect dangerous ultraviolet light

Scientists have developed a new device that can detect in just milliseconds a certain type of high-energy ultraviolet light which is powerful enough to break the bonds of DNA and harm living creatures.

Last Updated: Oct 06, 2013, 16:21 PM IST

Washington: Scientists have developed a new device that can detect in just milliseconds a certain type of high-energy ultraviolet light which is powerful enough to break the bonds of DNA and harm living creatures.

Although this radiation, called UVC, doesn`t normally reach Earth`s surface, it can leak through to just below the hole in the ozone layer.

Monitoring this radiation is a way of tracking the hole in the ozone layer, and photodiodes that measure UVC are also used as flame sensors and for communication in space.

Now, Shinji Nakagomi and colleagues at Ishinomaki Senshu University in Japan have built a new kind of photodiode that can detect the whole range of UVC light while remaining insensitive to visible light from the sun - two features that have eluded designers of current devices.

By being "solar blind," photodiodes are more sensitive to the UVC range and are thus more useful.

Some photo detectors consist of vacuum tubes on sale, but they have short lifetimes and are relatively large and unwieldy.

Today, many photodiodes are instead based on a so-called p-n junction, in which a semiconductor that carries positive charge (the absence of electrons called holes) is put in contact with the same semiconductor that instead carries negative charge (electrons).

When light with sufficient energy (short wavelength) strikes atoms near the interface between the two semiconductors - called p-type and n-type, respectively - it generates mobile electrons and holes, boosting electrical current across the p-n junction and signalling the presence of light.

Other photodiodes made from materials like aluminum nitride and diamond are sensitive only to a limited range of UVC light.

But recently, gallium oxide has shown promise because it`s sensitive to the entire UVC range and is solar blind. The problem, however, is that it`s difficult to make p-type gallium oxide.

Instead of a photodiode based on a conventional p-n junction, the researchers built one based on what`s called a heterojunction, which is a p-n junction that incorporates two different semiconductors.

The team used gallium oxide and silicon carbide, and found that their device responds quickly to UV light - within milliseconds - and has little dark current, which is the intrinsic electrical current that flows through the device even in the absence of light.

"The most important aspect about our device is that it is based on a heterojunction between gallium oxide and silicon carbide," said Nakagomi.

"This gallium oxide and silicon carbide photodiode is promising for the detection of UV light," Nakagomi said.

The study was published in the journal Applied Physics Letters, a journal of the American Institute of Physics.

PTI