Guwahati: Prime Minister Narendra Modi will inaugurate the Bogibeel Bridge - India`s longest rail-cum-road bridge - in Assam on Tuesday, December 25. 


COMMERCIAL BREAK
SCROLL TO CONTINUE READING

The foundation stone of the project was laid by former prime minister H D Deve Gouda on January 22, 1997, while work commenced on April 21, 2002, under the Atal Bihari Vajpayee-led government. 


Therefore, it is being inaugurated on late PM AB Vajpayee's birth anniversary on December 25.


Because of the inordinate delay in implementation, the cost of the project escalated by 85 per cent to Rs 5,960 crore from the sanctioned estimated cost of Rs 3,230.02 crore. 


Sharing more information, Railway PRO Nirpen Bhattacharya said, "This Bridge is the longest in India and is 4.94 km long. People would not know that this bridge is jointless. Latest technology has been used in constructing it. People of Arunachal Pradesh and Assam are going to benefit from it as north and south banks of river Brahmaputra will be connected."


Bhattacharya further said that it took 21 years to construct the bridge.


The 4.9 km-long Bogibeel Bridge on the Bramhaputra river is India's only fully welded bridge for which european codes and welding standards were adhered to for the first time in the country, said Chief Engineer Mohinder Singh. 


Singh said a fully welded bridge has a low maintenance cost.
 
The bridge, constructed at an estimated cost of Rs 5,900 crore, has a "serviceable period of around 120 years", he said.


The bridge reduces travel time from Assam to Arunachal Pradesh to four hours and will cut out the detour of over 170 km via Tinsukia. 


It will also reduce Delhi to Dibrugarh train-travel time by about three hours to 34 hours as against 37 hours presently.


The bridge has a two-line railway track on the lower deck and a three-lane road on the top deck. For the first time in Indian Railways, the girder has steel floor system for railway tracks and concrete for road.


"Early flood in the river Brahmaputra restricted the working season to a very short period of approximately five months (from November to March) and demanded huge mobilization of construction equipment," said Singh.


Transportation of concrete across river channels of 600 metre to 900 metre width from both the north and south banks was the biggest challenge, he said. 


To overcome this, concrete was pumped through pipeline laid over buoys.


"Eighty-thousand tonnes of steel plates was delivered for the project via a combination of rail and road transport, while a 1,000 tonne hydraulic jack and strand jacks linked with the substructures were used for moving steel truss over the pillars," he said. 


'Most 2D' automatic nesting software was used to generate efficient two-dimensional cutting plans for fabricating the steel superstructure for the bridge.


After December 25, people, especially patients from Assam Medical College located here, can travel straight from Dibrugarh from the other side of the river instead of using the ferries. 


The bridge is part of infrastructure projects planned by India to improve logistics along the border in Arunachal Pradesh. 


This includes the construction of a trans-Arunachal highway on the north bank of the Brahmaputra, and new road and rail links over the mighty river and its major tributaries such as the Dibang, Lohit, Subansiri and Kameng. 


(With Agency inputs)